invisibleShield installation tips

[Verchielle]

Ok, so I just installed my invisible shield (successfully) and perhaps might come handy in the future

Preparation

Before doing anything, please take a moment to look the installation demo video on http://www.shieldzone.com/application.html

Please make sure you have the all the spray solution, credit card/or that squeeze plastic and the invisible shield

Installation

I will not detail the step here because the instruction already have them, instead I will just offer some TIPS

Tips on screen cleaning

1. Avoid TISSUES. When you are wiping your screen, use a cloth instead of TISSUE. Tissue particles could stick on to your screen when you apply the shield and they are incredibly tiny micro and hard to wipe off. I used tissue and I spend 15 minutes cleaning those tiny particles until I ran out of the solution and I still left with some particles. [iriver clix carying case might be useful to clean off stuffs if its still clean] [use water when there is oily part on the screen / sweat [ ( a little bit )

2. Clean your screen completely. What I mean by completely is that make sure not even oil, fingerprint or dust in on the screen. Thats why its best to put invisibleshield just when you took iriver clix off from the box

3.Use your spray carefully. Although it seems alot - IT IS NOT. Be careful not to overuse them. You might need them a lot later especially if you got the screen completely

Tips on application

1. Make sure your hand is ALWAYS WET when dealing with the shield (using the spray)

2. When applying the Shield, make sure you dont use your hand pressing them down - instead use the PLASTIC / CREDIT CARD directly in smoothing them (instead of use hand and use credit card later).

3. Remove and reposition AS SOON AS you detect dusts/hair/fingerprint beneath the shield. To remove this object, you dont need to take off the shield completely. First you need just take off the shield on the specific part (nearest corner) and remove those objects with your WET FINGER. Remember, don't point the spray to the device, its better just to wet your finger. Once finished, re apply pressure with credit card / plastic.

Some Re-assurance

Don't expect to be perfect 100%. Some dusts inevitably will be left behind and thats perfectly fine. Remember, Invisibleshield is semi-permanent and dusts left behind doesnt mean that it wouldnt go forever.

Don't get stressed if its not perfect

Comment on the size

Yes, apparently there is this a very small incremental over in the shield size , of which this kinda goes off on the length (not height). But Im not troubled with it,

Please do ask question or comment if you have anything to add to the tips

[Verchielle]

after-math

Although it is REALLY tempting for say after 1-2 hours you see your clix and see something wrong to remove the invisibleShield, DONT. You must really do this in the first few minutes not in the first few hours. Consider whats done is done after 1-2 hours.