invisibleSHIELD size issues anyone?

[emorphien]

I just got my shield for my Clix and it appears to be a mm or two too wide, although the height of the shield is fine.

Anyone else noticing the same thing?


edit: ack I had to peel mine off. The corners at the ends weren't staying down and it was causing both ends to come up. It wouldn't stick back down after that

I'll wait for the update on whether they resize it now that they have a player to check against.

[Verchielle]

Many people complained this in the past and I believe Jeff is sending Clix to ShieldZone this week for further resizing

Someone said that the overlapping part will stuck eventually if u just try to fit them and leave it that way

I got my InvisibleShield today and will install tomorrow - I will keep you updated on mine

[emorphien]

I left it and when I looked at it an hour later it had lifted off. I tried to rewet and reapply the edges but they just won't take. I guess it's one shot and you're done, the magic is gone.

[emorphien]

bumping for update from invisibleSHIELD about whether they resized the screen protector.

[Verchielle]

Mine does have excess size too, and it kinda non-stick to the screen and start to accumulate dust

[emorphien]

I guess you and I can wait for an update and perhaps revised shields... otherwise I guess I don't want mine

[Verchielle]

So u did take off yours ? issit hard to to peel off ?

[emorphien]

It takes some effort. The parts that stick really stick.

I just installed their shields on my pro digital camera (one for back displays, one for the top display) and sizing worked out pretty well and they attached nicely.

[MiniTurtle]

All you had to do was trim the end off with scissors, then it works just fine. If it bumps up along the edge then just flatten it down and hold it for a few seconds. If you peeled it off and now its all dusty and not sticky, then clean it with water and reapply (water does not affect the stickiness, I've tried).

[emorphien]

I'd rather wait for a better fit. While I can trim it, I'd rather have the quality of edge that invisibleSHIELD can produce, not me with a pair of scissors.

[Verchielle]

Originally Posted by MiniTurtle

All you had to do was trim the end off with scissors, then it works just fine. If it bumps up along the edge then just flatten it down and hold it for a few seconds. If you peeled it off and now its all dusty and not sticky, then clean it with water and reapply (water does not affect the stickiness, I've tried).

What is the possibility for me to remove all the invisibleShield and reapply it using water ?... issit by all mean possible ?

[emorphien]

I got bored, any updates?