Took H120 apart, where does this part go?

[BlueRiver]

I took apart my H120 to replace the screen and when I put the entire player back together I ended up with an extra tiny rubber piece. For the life of me I don't remember where it goes.

The rubber piece in question is about 0.25 x 0.25 inch (~6mm) and has two tiny holes on the left and right. The rubber is the same type rubber the gasket that goes over the HDD is made of. Any idea where this is supposed to go?

[jumbuck]

I just had a look at whats left of a old mother board and there are two rubber blocks on either side which are about 6mm * 6mm * 3mm.
You can see them on the board just outside of the angle blocks.
I cant see any holes in them though...
(sorry for the dodgey photo)

[BlueRiver]

Thanks, but, are you sure those are not IC chips? On my h120 (U.S. Version) there are chips with soldering points.

The rubber piece in question has some kind of indentation which leads me to believe it's supposed to fit on a switch or act as a spacer on something that sticks out on the motherboard.

[jumbuck]

Originally Posted by BlueRiver

Thanks, but, are you sure those are not IC chips? On my h120 (U.S. Version) there are chips with soldering points.

They are definitively rubber blocks , (unless iriver uses space age rubber IC's that are glued to the board ).