Boot logo Help

[midas22]

I made my boot logo for my iHP-120 (below), I saved it as a 265 colour bitmap , measurements are 104 x 88, the file name is 0.bmp, i have it saved into the direrctory for ihplogo (C:\Documents and Settings\Derek\My Documents\Programs\i hplogo\0.bmp)
When I run ihplogo.bat, put in 0 for the file i wish to change then put in the location of the file i wish to switch to the cmb prompt says soemthing then suts down (too fast for me to read what it says) with out creating the new firmware. I have tried with with other .bmp files that I have not made and it works, so it had to be an issue with my .bmp but I have no idea what it would be.

[NPswimdude500]

it needs to be 4-bit greyscale. 8-bit greyscale also works

[midas22]

I ahve it saved as an 8bit, 4 bit is disabled from photoshop for somereason and it still doesnt work

here is the log file from when I used iHP Graphics Customizer:

C:\Program Files\iHP Graphics Customizer\iHPLogo\i hpfirm.exe -d -i "C:\Documents and Settings\Derek\My Documents\Programs\i hplogo\OriginalFirmw are\ihp_120.hex" -o "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out"
Model iHP-120/iHP-140
File decoded correctly and all checksums matched!
Output file contains all headers and checksums

C:\Program Files\iHP Graphics Customizer\iHPLogo\i hpbmp.exe "C:\Program Files\iHP Graphics Customizer\Themes\de rek\0.bmp" -x 0 -c -i "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out" -o "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out"
iHPBMP version 1.1.01 (c)2004 @spc
http://www.beermex.com/@spc/iriver/ihpbmp
Model iHP-120/iHP-140
This is not a greyscale image! Only bitmaps using shades of grey are
supported - convert using an image editor first

^^^^^########## ERROR ##########^^^^^

C:\Program Files\iHP Graphics Customizer\iHPLogo\i hpbmp.exe "C:\Program Files\iHP Graphics Customizer\Themes\de rek\1.bmp" -x 1 -c -i "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out" -o "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out"
iHPBMP version 1.1.01 (c)2004 @spc
http://www.beermex.com/@spc/iriver/ihpbmp
Model iHP-120/iHP-140
Image successfully replaced!

C:\Program Files\iHP Graphics Customizer\iHPLogo\i hpfirm.exe -e -i "C:\Program Files\iHP Graphics Customizer\iHPLogo\n ew.out" -o "C:\Documents and Settings\Derek\My Documents\Programs\i hplogo\ihp_120.hex"
Model iHP-120/iHP-140
File encoded successfully and checksum table built!

[midas22]

could someone save the bootlogo at a 4-bit grey scale for me, i ahve done this and it still sint working.

[Haku]

here ya go

[midas22]

thanks so much haku.